Lenovo 5214, 5354, 3425, 3980 manual Diagnostic error code FRU/Action

Diagnostic error code		FRU/Action
086-199-XXXMouse port interface test failed, cause	1. See “Undetermined problems” on page 64
unknown	2.	Flash the system and re-test. See “Updating
		(flashing) BIOS from a disc” on page 99
	3.	Replace component under function test
089-000-XXXMicroprocessor test passed	No action
089-XXX-XXXMicroprocessor failure	1. Microprocessor(s)
	2.	System board
089-195-XXXMicroprocessor test aborted by user	Information only Re-start the test, if necessary
089-196-XXXMicroprocessor test halt, error threshold	1.	Press F3 to review the log file
exceeded	2.	Re-start the test to reset the log file
089-197-XXXMicroprocessor test warning	1. Make sure the component that is called out is
		connected and/or enabled. See Chapter 6 “Using the
		Setup Utility” on page 41
	2.	Re-run test
	3.	Replace the component that is called out in warning
		statement
	4.	Replace the component under test
089-198-XXXMicroprocessor test aborted	1. Flash the system. See “Updating (flashing) BIOS
		from a disc” on page 99
	2.	Go to “Undetermined problems” on page 64
089-199-XXXMicroprocessor test failed, cause unknown	1. See “Undetermined problems” on page 64
	2.	Flash the system and re-test. See “Updating
		(flashing) BIOS from a disc” on page 99
	3.	Replace component under function test
170-000-XXXVoltage sensor(s) test passed	No action
170-0XX-XXXVoltage sensor(s) failure	1. Flash system
	2.	System board
170-195-XXXVoltage sensor(s) test aborted by user	Information onlyRe-start the test, if necessary
170-196-XXXVoltage sensor(s) test halt, error threshold	1.	Press F3 to review the log file
exceeded	2.	Re-start the test to reset the log file
170-197-XXXVoltage sensor(s) test warning	1. Make sure the component that is called out is
		connected and/or enabled. See Chapter 6 “Using the
		Setup Utility” on page 41
	2.	Re-run test
	3.	Replace the component that is called out in warning
		statement
	4.	Replace the component under test
170-198-XXXVoltage sensor(s) test aborted	1. If a component is called out, make sure it is
		connected and/or enabled. See Chapter 6 “Using the
		Setup Utility” on page 41
	2.	Flash the system and re-test. See “Updating
		(flashing) BIOS from a disc” on page 99
	3.	Go to “Undetermined problems” on page 64

58Hardware Maintenance Manual