Note: If you do not want to save the settings, select Discard Changes and Exit.
To set the Floppy A, do the following:
1.Start the Setup Utility program. See “Starting the Setup Utility program” on page 19.
2.From the Setup Utility program menu, select Devices → Floppy Drive Setup → Floppy A.
3.Select the desired settings and press Enter.
4.Return to the Setup Utility program menu and select Exit → Save Changes and Exit.
Note: If you do not want to save the settings, select Discard Changes and Exit.
Selecting a startup device
If your computer does not start up from a device such as the
Selecting a temporary startup device
Use this procedure to startup from any start device.
Note: Not all discs, hard disk drives, and diskettes are bootable.
1.Turn off your computer.
2.Press and hold the F12 key, then turn on the computer. When the Startup Device Menu appears, release the F12 key.
Note: If you are using a USB keyboard and the Startup Device Menu does not display using this method, repeatedly press and release the F12 key rather than leaving it pressed when turning on the computer.
3.Select the desired startup device from the Startup Device Menu and press Enter to begin.
Note: Selecting a startup device from the Startup Device menu does not permanently change the startup sequence.
Selecting or changing the startup device sequence
To view or permanently change the configured startup device sequence, do the following:
1.Start the Setup Utility program. See “Starting the Setup Utility program” on page 19.
2.Select Startup → Startup Sequence.
3.See the information displayed on the right side of the screen.
4.Select the devices for the Primary Startup Sequence, the Automatic Startup Sequence, and the Error Startup Sequence.
5.From the Setup Utility menu, select Exit → Save Changes and Exit.
If you have changed these settings and want to return to the default settings, select Load Default Settings on the Exit menu.
Chapter 5. Using the Setup Utility 21
