Lenovo G41 manual Recover to Factory Contents

		Symptom-to-FRU index
Symptom or error	FRU or action, in sequence
02F5	1.	DIMM.
DMA test failed	2.	System board.
02F6	1.	DIMM.
Software NMI failed	2.	System board.
02F7	1.	DIMM.
Fail-safe timer NMI	2.	System board.
failed
1802	1.	Remove Mini PCI network card.
Unauthorized	2.	System board.
network card is
plugged in—Power
off and remove the
miniPCI network
card.
1803	1.	Remove the daughter card.
Unauthorized	2.	System board.
daughter card is
plugged in—Power
off and remove the
daughter card.
1810	1.	If the Access IBM Predesktop Area
Hard disk partition		has been previously disabled, then
layout error		go to the BIOS Setup Utility by
		pressing F1 to open the BIOS Setup
		Utility. Select Security->Predesktop
		Area->Access IBM Predesktop Area.
		Set this item to Disabled. Save and
		Exit.
	2.	If the Access IBM Predesktop Area
		has been previously disabled, press
		Enter to load Access IBM Predesktop
		Area. Then run RECOVER TO
		FACTORY CONTENTS in Access IBM
		Predesktop Area.
	3.	If item 2 failed, press F3 in the
		welcome screen in RECOVER TO
		FACTORY CONTENTS Run FDISK,
		and then delete all partitions. Run
		RECOVER TO FACTORY CONTENTS
		in Access IBM Predesktop Area again.
	4.	If item 3 failed, select CD-ROM boot in
		RECOVER TO FACTORY CONTENTS
		Run FDISK, and then delete all
		partitions. Run Startup in Access IBM
		Predesktop Area. Boot from Recovery
		CD and perform full recovery from it.
	5.	If item 4 failed, replace the hard disk
		drive.

ThinkPad G40, G41 55