Lenovo T54H manual Auto Setup, Japanese Italiano Español Deutsch Français, Compl & Warr, English

U65C`tfuvq/cbdlvq/gnQbhf:Xfeoftebz-Kvmz23-31115;1:QN

Auto Setup

ENGLISH

Auto Setup

Before carrying out this section, it is very

important that The Setup Diskette for Windows 95 or Windows 98/Windows 2000/ Windows NT has been run. (see page 6)

The Setup Utility included on the setup diskette is for displaying do patterns. They do not replace or modify the display dirver.

The Auto Setup instructions require the monitor to be warmed up for 15 minutes. This is not required for normal operation.

￿By pressing the and ￿keys

simultaneously allows direct access to the auto set-up controls.

If your PC does not run with the setup diskettes

shipped with the monitor, refer to Manual Setup on page 12

When you first use your monitor you must perform Auto Setup. This procedure sets up your monitor to process the video signals from your computer without image discoloration or smearing. After you perform Auto Setup, the settings are stored and used each time you turn on the monitor.

In order to optimise the displayed image a set-up utility is provided on the IBM Monitor Installation Diskette. Operation of the utility is dependent on the operating system on your PC. For correct operation locate the operating system on your PC from the table below and follow the appropriate instructions. You may choose to run AUTO SETUP for each operating system that you use. This means that if you sometimes use your monitor while running any version of Windows and sometimes also use it from within DOS (not a DOS window), you must run AUTO SETUP for both Windows and DOS. You may run versions of AUTO SETUP in any order.

Operating System Corresponding Auto Setup procedure

DOS	Auto Setup for DOS on page 9
Windows 3.1
Windows 95	Auto Setup for Windows 3.1, Windows 95,
Windows 98	Windows 98, Windows 2000 or Windows
	NT on page 11
Window 2000
Window NT

Before you begin AUTO SETUP for your PC:

1.Make a backup copy of the setup diskettes supplied with the monitor.

JAPANESE ITALIANO ESPAÑOL DEUTSCH FRANÇAIS

2.Make sure the PC’s video mode is set in the range of the supported screen resolution shown in the table on page 18.

The AUTO SETUP process You should perform AUTO SETUP for each screen mode you use.

only applies to the current screen mode. When a new mode is selected, repeat this section to reset the monitor

COMPL & WARR

9