U65C`tfuvq/cbdlvq/gnQbhf22Xfeoftebz-Kvmz23-31115;1:QN
Auto Setup for Windows 3.1, Windows 95, Windows 98, Windows NT or Windows 2000
ENGLISH
If the monitor is in standby mode (STANDBY ON), it
may automatically turn off while you are waiting for it to warm up.
The size and diversity of the dot pattern varies with
the screen resolution.
1.Turn on the monitor first; then the PC.
If the message CHECK SIGNAL CABLE is displayed, or if nothing is displayed check:
•that the video interface cable is connected properly.
•the correct video adapter card is installed.
•the correct supported display mode is selected for your PC.
2.Wait approximately 15 minutes, until the monitor warms up.
3.Drag the icon bar and tool bar, if they are displayed, to the bottom of the screen.
4.Insert the diskette labelled ‘IBM Flat Panel Monitor Installation Disk’ into the diskette drive.
5.Check the operating system installed on your PC and follow the instructions from the table below.
ESPAÑOL DEUTSCH FRANÇAIS
Position the mouse pointer at the bottom center of the
screen. This allows AUTO SETUP to run properly
Operating | Step1 | Step2 | Step3 | Step4 | |
System | |||||
|
|
|
| ||
|
|
|
|
| |
|
|
|
|
| |
Windows 3.1 | Open | Select | Select |
| |
| PROGRAM |
| |||
Windows NT 3.5 | FILE | RUN |
| ||
MANGER |
| ||||
|
|
| Type | ||
|
|
|
| ||
Windows 95 |
|
|
| ||
|
|
| ‘A:\TESTPAT’ | ||
|
|
|
| and press | |
Windows 98 | Select |
|
| ||
Select RUN | ENTER | ||||
| |||||
Windows 2000 | START |
| |||
|
|
| |||
|
|
|
| ||
|
|
|
|
| |
Windows NT 4.0 |
|
|
|
| |
6.When the test pattern appears, press the OSD Enter button 
at the bottom of the monitor to display the initial OSD menu.
7.Use an Arrow button ( 
or 
) to select the IMAGE LOCK icon 
and press the OSD Enter button 
to access the function.
8.Using an Arrow button ( 
or 
), select AUTOMATIC and press the
OSD Enter button 
. This activates the AUTO SETUP procedure, which will optimize the display settings with the provided test pattern.
The screen will dim, blink on and off several times, and you may notice small changes to the test pattern.
To abort the AUTO SETUP function, press the ESC key.
COMPL & WARR JAPANESE ITALIANO
11
