Lenoxx Electronics PDV-709 instruction manual Playing a Disc

1. PLAYING A DISC

1 Lift the LCD screen.

2 Slide the DVD player’s POWER switch to the ON position, the DVD logo (start-up picture) will appear on the screen.

3 Press the OPEN button on the DVD player to open the disc door. Place a disc gently on the tray with the label side up, make sure the disc is seated on the spindle by pressing down in the center, then close the door by pushing it down. The DVD player starts to read the disc’s table of contents (this may take a few seconds).

NOTE 1: Load the disc with the label side facing up, when

playing a double-sided disc, load it with the desired

playing side face down.

NOTE 2: “NO DISC” will show in the display if the disc is upside down or the disc is badly scratched or dirty, it will not play. Please clean it or change the disc before use. Also you can buy a disc polisher to try to repair the scratched disc.

4 Some discs will start playing automatically, and others will display the Disc Contents Menu on

the screen. If the menu is shown, use the ( ,	, & ) direction buttons to highlight your
selection and press the OK button to confirm, otherwise you may press play.
5 Press the VOLUME + or VOLUME – button to adjust the volume level.
6 Press the SCREEN ON/OFF button on the remote control, then press the left			and right
direction buttons to adjust the brightness and the color of the LCD screen if needed.
7 To stop playback, press the STOP button.
8 To pause the playback, press the OK button	on the remote control or the PLAY/PAUSE
button on the player. To resume playback, press the OK button		on the remote control
or the PLAY/PAUSE button on the player again.
NOTE 1: During play, pressing the STOP button once will show “PRE STOP			” in the
display, if you press the STOP button the second time, the display will show
“STOP ”, and now your system is in the full STOP mode.

NOTE 2: Leaving the set in the stop mode for a longer time will drain the battery the same

as during normal play, remember to shut off the power after use.
9 To skip to another track/chapter, press the SKIP/SEARCH	or SKIP/SEARCH	button
repeatedly during playback.

10 To access the disc menu or title menu during DVD play, press the MENU or TITLE button on the remote control or on the DVD player.

11 Remember to shut off the player by sliding the POWER switch to the OFF position when the movie finishes playing.

NOTE: This player has a screen saver which will display a bouncing DVD logo if no video is played for a while.

10 IB-PDV709-WM-E-061006

IB-PDV709-WM-E-061006.pmd11

8/3/2006, 11:00 AM