Connecting the printer to a wireless network using the Embedded Web Server

Before you begin, make sure that:
•Your printer is connected temporarily to an Ethernet netwo rk.
•A wireless network adapter is installed in your printer and working properly. For more information, see the
instruction sheet that came with the wireless network adapte r.
1Open a Web browser, and then type the printer IP address in the address field.
Notes:
•View the printer IP address on the printer control panel. The IP address appears as four sets of numbers
separated by periods, such as 123.123.123.123.
•If you are using a proxy server, then temporarily disable it to load the Web page correctly.
2Click Settings > Network/Ports > Wireless.
3Modify the settings to match the settings of your a ccess point (wireless router).
Note: Make sure to enter the correct SSID, security m ethod, preshared key or passphrase, network mode, and
channel.
4Click Submit.
5Turn off the printer, and then disconnect the Ethernet cable. Then wait for at least five seconds, and then turn the
printer back on.
6To verify if your printer is connected to the network, print a network setup page. Then in the Network Card [x]
section, see if the status is Connected.
Verifying printer setup

Printing a menu settings page

Print a menu settings page to review the current menu settings and to veri fy if the printer options are installed correc tly.
Note: If you have not changed any menu settings, then the menu setti ngs page lists all the factory default settings.
When you select and save other settings from the menus, they replace the factory default settings as user default
settings. A user default setting remains in effect until you access the menu again, choose another value, and save it.
From the printer control panel, navigate to:
> Settings > >Reports > > Menu Settings Page >
Additional printer setup 32