CONNECTIONS & SETUP
33
Screen Setup for PC mode
Overview
This function works in the following mode:
Component1, Component2, RGB-PC, RGB-DTV, or HDMI/DVI.
Note: Some signal from some graphics boards may not function properly. If the results are unsatisfactory, adjust
your monitor’s position, size and phase manually.
Adjustment for screen Position, Clock, Phase
Press the OOKKbutton and then use DDor EEbutton to select
PPoossiittiioonn, CClloocckk, or PPhhaassee.
Press the GGbutton and then use DDEE FFGG button to
make appropriate adjustments.
■The PPhhaasseeadjustment range is --3322 ~++3322.
The PPhhaasseeonly works in Component 1-2, RGB-PC and
RGB-DTV mode.
■The CClloocckkadjustment range is --5500 ~++5500.
The CClloocckkonly works in RGB-PC mode.
Press the OOKKbutton.
Initializing (Reset to original factory values)
Press the OOKKbutton and then use DDor EEbutton to select
RReesseett.
Press the GGbutton and then use FFor GGbutton to select
YYeess.
Press the OOKKbutton.
To initialize the adjusted values
This function allows you to return to the good picture repro-
duction programmed at the factory and cannot be change.
1
2
3
1
2
3
123
123
Position
Clcok
Phase
Reset GG
Position GG
Clcok
Phase
Reset
PPoossiittiioonnThis function is to adjust picture
to left/right and up/down as you
prefer.
CClloocckkThis function is to minimize any
vertical bars or stripes visible on
the screen background. And the
horizontal screen size will also
change.
PPhhaasseeThis function allows you to
remove any horizontal noise and
clear or sharpen the image of char-
acters. In HDMI/DVI-PC mode,
PHASE is not available.
Initialize Settings
EE
DD
FFGG
Close
Close
9U0569A-1 Rev05-ING 06/8/23 3:28 PM Page 33