IMPORTANT SAFETY INSTRUCTIONS

5

yyDot Defect

For USA and Canada

 

 

 

The panel is a high technology product with

 

 

 

 

 

 

 

 

resolution of two million to six million pixels.

 

 

 

 

 

 

 

FCC NOTICE

 

 

 

 

In a very few cases, you could see fine dots

 

 

 

 

on the screen while you’re viewing the TV.

This equipment has been tested and found

 

 

Those dots are deactivated pixels and do not

 

 

to comply with the limits for a Class B

 

 

affect the performance and reliability of the

 

 

digital device, pursuant to Part 15 of the

 

 

TV.

 

 

FCC Rules. These limits are designed to

 

yyGenerated Sound

 

provide reasonable protection against harmful

 

 

Cracking noise: A cracking noise that occurs

 

 

interference in a residential installation.

 

 

when watching or turning off the TV is

 

 

This equipment generates, uses and can

 

 

generated by plastic thermal contraction

 

 

radiate radio frequency energy and, if not

 

 

due to temperature and humidity. This noise

 

 

installed and used in accordance with the

 

 

is common for products where thermal

 

 

instructions, may cause harmful interference

 

 

deformation is required.

 

 

to radio communications. However, there is

 

 

Electrical circuit humming/panel buzzing: A

 

 

no guarantee that interference will not occur

 

 

low level noise is generated from a high-

 

 

in a particular installation. If this equipment

 

 

speed switching circuit, which supplies a

 

 

does cause harmful interference to radio or

 

 

large amount of current to operate a product.

 

 

television reception, which can be determined

 

It varies depending upon the product.

 

by turning the equipment off and on, the user

 

 

This generated sound does not affect the

 

 

is encouraged to try to correct the interference

 

performance and reliability of the product.

 

by one or more of the following measures:

 

yyTake care not to touch the ventilation

 

- Reorient or relocate the receiving antenna.

 

 

openings. When watching the TV for a long

 

 

period, the ventilation openings may become

- Increase the separation between the

 

 

hot. This does not affect the performance of

 

equipment and the receiver.

 

 

the product or cause defects in the product.

- Connect the equipment to an outlet on

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

a circuit different from that to which the

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

receiver is connected.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

- Consult the dealer or an experienced

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

radio/TV technician for help.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

This device complies with part 15 of the FCC

 

Preventing

image burn or burn-in on your

 

 

 

Rules. Operation is subject to the following

 

TV screen

 

two conditions: (1) this device may not cause

 

 

 

 

 

 

 

 

 

 

 

 

 

harmful interference and (2) this device must

 

 

 

 

 

 

 

 

 

 

 

 

 

accept any interference received, including

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

interference that may cause undesired

 

 

 

 

 

 

 

 

 

 

 

 

 

 

operation of the device.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Any changes or modifications in construction

 

 

 

 

 

 

 

 

 

 

 

 

 

yyIf a fixed image displays on the TV screen for

of this device which are not expressly

 

approved by the party responsible for

 

 

a long period of time, it will be imprinted and

 

 

compliance could void the user’s authority to

 

become a permanent disfigurement on the

 

operate the equipment.

 

 

screen. This is image burn or burn-in and not

 

 

 

 

 

 

 

 

covered by the warranty.

NOTE TO CABLE/TV INSTALLER

 

yyIf the aspect ratio of the TV is set to 4:3 for a

 

long period of time, image burn may occur on

This reminder is provided to call the CATV

the letterboxed area of the screen.

system installer’s attention to Article 820-

yyAvoid displaying a fixed image on the TV

40 of the National Electric Code (U.S.A.).

screen for a long period of time (2 or more

The code provides guidelines for proper

hours for LCD, 1 or more hours for the

grounding and, in particular, specifies that

Plasma TV) to prevent image burn.

the cable ground shall be connected to the

 

 

grounding system of the building, as close to

 

the point of the cable entry as practical.

ENGLISH

Page 5
Image 5
LG Electronics 60PB5600 owner manual TV screen, YyDot Defect For USA and Canada, YyGenerated Sound