Review the following options to determine the for your home:
4-wire receptacle (NEMA type14-30R)
Use the instructions at this section if your home has a
3-wire receptacle (NEMA type10-30R)
Use the instructions at this section if your home has a
4-wire connection : Direct wire
Important : use
Prepare minimum 5ft(1.52m) of length in order for dryer to be replaced.
First, peel 5 inch (12.7cm) of covering material from end. Make a 5 inch of ground wire bared. After cutting 11/2 inch (3.8cm) from 3 other wires. peel insulation back 1inch (2.5cm). Make ends of 3 wires a hook shape.
4-wire direct
If this type is available at your home. you will be connecting to a fused disconnect or circuit breaker box
3-wire direct
If this type is available at your home. you will be connecting to a fused disconnect or circuit breaker box
Note
•Screw power supply wire to the terminal block. Colored wire should be connected to same color screw. Wire color indicated on manual is connected to the same color screw in block. Otherwise, excessive current is applied resulting in damages on product and heating failure.
•Appropriate screwing is essential. Imcomplete screwing also may cause loose connection or unscrewing because of excessive screw abrasion.
•Loose screwing may cause connection error, which result in death, fire or serious injury.
Then, put the hooked shape end of the wire under the screw of the terminal block(hooked end facing rightward) and pinch the hook together and screw tightly.
1.Connect neutral wire(white) of power cord to center terminal block screw.
2.Connect red and black wire to the left and right terminal block screws.
3.Connect ground wire(green) of power cord to external ground screw and move neutral ground wire of appliance and connect it to center screw.
4.Make sure that the strain relief screw is tightened.
and be sure that all terminal block nuts are on tight and power cord is in right position.
1 5