LG Electronics F1443KDS owner manual Connect hose to washer, When your washer has two valves

I nstallation

Type-C : Connecting one touch type hose to tap without thread

		1. Unscrew the adapter ring plate and
		the 4 adapter retaining screws.
Ring plate		2. Remove the guide plate if the tap is
		too large to fit the adapter.
Guide plate
		3. Push the adapter onto the end of
		the tap so that the rubber seal forms
		a watertight connection.
		Tighten the adapter ring plate and
		the 4 screws.
		4. Pull the connector latch plate down,
		push the inlet hose onto the adapter,
		and release the connector latch plate.
		Make sure the adapter locks into place.
		After connecting inlet hose to
		water tap, turn on the water tap
		to flush out foreign substances
	Latch plate	(dirt, sand or sawdust) in the
		water lines. Let water drain into a
		bucket, and check the water
		temperature.

Step3: Connect hose to washer

• Make sure that there are no kinks in the hose and that they are not crushed.

When your washer has two valves.

• The Inlet hose which has red connector is for the hot water tap.

• If the washer has two valves, the energy is saved by using hot valve.

After completing connection, if water leaks from the hose, repeat the same steps. Use the most conventional type of faucet for water supply. In case the faucet is square or too big, remove the spacing ring before inserting the faucet into the adaptor.

Use the horizontal tap

Horizontal tap

Extension tap

Square tap

10