Installation
■Installation place requirements
Washer |
approx. |
2cm |
❿Location
•Level floor :
Allowable slope under entire washer is 1˚
•Power outlet :
Must be within 1.5 meters of either side of location of washer. Do not overload the outlet with more than one appliance.
•Additional Clearance :
For Wall, 10cm:rear / 2cm : right & left side
Do not place or store laundry products on top of washer at any times.
They can damage the finish or controls.
❿Positioning
•Install the washer on a flat hard floor.
•Make sure that air circulation around the washer is not impeded by carpets, rugs, etc.
•Never try to correct any unevenness in the floor with pieces of wood, cardboard or similar materials under the washer.
•If it is impossible to avoid positioning the washer next to a gas cooker or coal burning stove,an insulating(85x60cm) covered with aluminum foil on the side facing the cooker or stove,must be inserted between the two appliance.
•The washer must not be installed in rooms where the temperature can drop below 0°C.
•Please ensure that when the washer is installed, it is easily accessible for the engineer in the event of a breakdown.
•With the washer installed, adjust all four feet using the transit bolt spanner provided ensuring the appliance is stable, and a clearance of approximately 20mm is left between the top of the washer and the underside of any
•This equipment is not designed for maritime use or for use in a mobile installations such as caravans, aircraft etc.
10
