Installation
■Connecting water supply hose
•Water supply pressure must be between 100 kPa and 1000 kPa (1.0 - 10.0 kgf / cm2).
•Do not strip or crossthread when connecting inlet hose to the valve.
•If the water supply pressure is more than 1000 kPa, a decompression device should be installed.
•Periodically check the condition of the hose and replace the hose if necessary.
❿Step1 : Check rubber seal inlet hose
Hose connector
Rubber seal
Hose connector
Rubber seal
•Two rubber seals are supplied with the water inlet hoses.
They are used for preventing water leaks. Make sure the connection to taps is sufficiently tight.
❿Step2 : Connect hose to water tap
Type-A : Connecting Screw-type hose to tap with thread
• Screw the hose connector onto water supply tap.
12
