REFRIGERATOR INSTALLATION
3. Removing Refrigerator Handle
NOTE: To assist in installing the handle on the right side, place a small piece of masking tape near the top of the handle before removing.
Grasp the handle tightly with both hands and slide the handle up (1)(this may require some force).
The keyhole slots (2) on the back of the handle allow the handle to separate from the mounting screws (3).
Use an adjustable wrench to remove the handle mounting screws (3).
Carefully pry off the plug buttons (4).
Install the plug buttons (4) on left side.
Install the handle mounting screw (3) on the right side
Hold the handle so the masking tape is at the bottom.
Align keyhole slots (2) on the top and bottom of the back of the handle with the screws (3) mounted on the front of the door.
Press the handle against the door front, making sure that the screws (3) go into the keyhole slots (2).
Grasping the handle with both hands, press it firmly against the front of the door and slide the handle down (6). This may require some force.
1
3
Screws mounted on door
2
Keyhole slots on back of handle
4
3
2
Keyhole slots on back of handle
6
3
Screws mounted on door
16
