CONNECTING THE WATER LINE
9.CONNECT THE TUBING TO THE REFRIGERATOR
Removing and Replacing Valve Cover
NOTE:
•Before making the connection to the refrigerator, be sure the refrigerator power cord is not plugged into the wall outlet.
1.Place a compression nut and a ferrule(sleeve) onto the end of tubing.
Compression Nut
Ferrule (sleeve)
2.Insert the tube into the valve and fasten with wrench as shown in the figure below.
Tubing
wCAUTION: Check to see if water dripping occurs at water line connections.
10.TURN THE WATER ON AT THE SHUTOFF VALVE
Tighten any connections that leak.
Reattach the compressor compartment access cover.
11. PLUG IN THE REFRIGERATOR
Arrange the coil of tubing so that it does not vibrate against the back of the refrigerator or against the wall. Push the refrigerator back to the wall.
12. START THE ICEMAKER
Set the icemaker power switch to the ON position. The icemaker will not begin to operate until it reaches its operating temperature of 15°F
32
