LG Electronics LRE30755S Part 4 INSTALL THE RANGE, Anti-Tip Device Installation, Level the range

Part 4 INSTALL THE RANGE

Replace the access cover on the range back. To replace the wire cover, insert double projections in the pockets located below the opening and tighten the three screws.

5ANTI-TIP DEVICE INSTALLATION

WARNING

•To reduce the risk of tipping, the appliance must be secured by properly installed anti-tip devices packed with the appliance.

•See instructions to install (supplied with bracket).

•Unless properly installed, the range could be tipped by stepping or sitting on the door. Injury may result from spilled hot liquids or from the range itself.

Note

To install Anti-tip bracket, release the leveling leg. A minimum clearance of 0.65”(16.5mm) is required between the range bottom and the kitchen floor.

1.Locate the bracket using the template

An Anti-tip bracket is packaged with template. The instructions include necessary information to complete the installation.

Read and follow range installation instruction sheet (template).

2.Level the range

Level the range by adjusting the leveling legs with a wrench.

Use a spirit level to check your adjustments. Place the level diagonally on the oven rack, and check each direction for level.

First check direction 1 .

After check direction 2 .

If the spirit level doesn’t show level on the rack, adjust the leveling legs with a wrench.

6FINAL INSTALLATION

•Move range close enough to the opening to plug into the receptacle.

•Slide range into position insuring that the left back leg slides under the anti-tip bracket. Range will sit 0” away from the back wall when properly installed.

•Carefully tip range forward to insure that the anti-tip bracket engages the range back brace and prevents tip-over.

•Turn on electrical power. Check range for proper operation as described in owner’s manual.

8