Installation
Door removal
Warning
Remove lower cover and
then feed water
tube
Electric Shock Hazard
Disconnect electrical supply to refrigerator before installing. Failure to do so could result in death or serious injury.
If your access door is too narrow for the refrigerator to pass through, remove the refrigerator door and pass the refrigerator laterally.
Remove the lower cover by lifting upward, and then pull up the feed water tube while pressing area shown in the figure to the right.
NOTE
•If a tube end is deformed or abraded, cut the part away.
Lower cover
Feed water tube
Remove the freezer
compartment
door
1)Removing the hinge cover by loosening the screws. Separate all connection wires except for the earth line after.
2)Remove the keeper by rotating it counter
clockwise ( ) and then lifting the upper hinge up ( ).
Hinge cover
Keeper |
Connection wires
Earth line
Upper hinge
NOTE
•When removing the upper hinge, be careful that the door does not fall forwards .
3) Remove the freezer compartment door by lifting it upward. This time, the door should be lifted enough for the feed water pipe tube to be completely pulled out.
Lower hinge
NOTE
•Move the refrigerator compartment door passing through the access door and lay it down, but be careful not to damage the feed water pipe tube.
Remove the refrigerator
door
1) Loosen the hinge cover screws and remove the cover. Remove connection wire, if any, except for the earth line.
Connection 
wires 
2) Remove keeper by rotating it clockwise ( | ) | Upper hinge |
and then remove the upper hinge by lifting |
| |
|
| |
it up ( ). |
|
|
Keeper
3)Remove the refrigerator compartment door by lifting it up.
6 | Lower hinge |
|
