Installation
Warning
Remove Lower
Cover and
Water Feed Tube
Door removal
Electric Shock Hazard
Disconnect electrical supply to refrigerator before installing.
Failure to do so could result in death or serious injury.
If your entrance door is too narrow for the |
|
refrigerator to pass through, remove the | Lower Cover |
refrigerator door and pass the refrigerator laterally. |
|
Remove the lower cover by lifting upward, and |
|
then pull up the water feed tube while pressing |
|
area shown in the figure to the right. | Water Feed Tube |
NOTE
•If a tube end is deformed or abraded, trim the part away.
Disconnecting the tube under the door causes about 1.5 litters water to flow out. Please put a large container at end of tube to prevent water from draining on to the floor.
Remove the
Freezer
Compartment
Door
1) Remove the hinge cover by loosening the screws. Disconnect all connections except the ground line.
Upper Hinge
2) Remove the keeper by rotating it counter clockwise and then lifting the upper hinge up .
NOTE
Hinge
Cover
Keeper
Connection
Wires
Earth Line
Upper Hinge
•When removing the upper hinge, be careful that the door does not fall forward .
3) Remove the freezer compartment door by lifting it upward. This time, the door should be lifted enough for the water feed tube to be completely pulled out.
Lower hinge
NOTE
•After removing the door, take it into the kitchen where you are installing the refrigerator. Lay it down on a blanket and be careful to avoid damaging the water feed tube.
Remove the
Refrigerator
Door
1)Loosen the hinge cover screws and remove the cover. Remove connection wire.
2)Remove keeper by rotating it clockwise and then remove the upper hinge by lifting
it up .
3)Remove the refrigerator compartment door by lifting it up.
Connection
Wires
Upper Hinge
Keeper
8 | Lower Hinge |
6
