Installation
Connect the tubing to Before making the connection to the refrigerator, be sure the refrigerator the refrigerator power cord is not plugged into the wall outlet.
•If your refrigerator does not have a water filter, we recommend installing one. If your water supply has sand or particles, that could clog the screen of the refrigerator’s water valve. Install the filter in the water line near the refrigerator. TubingClamp
1/4" Tubing
FerruleNutCompression(sleev)1/4"
RefrigeratorConnection
1.Remove the plastic flexible cap from the water valve.
2.Place the compression nut and ferrule (sleeve) onto the end of the tubing as shown.
3.Insert the end of the copper tubing into the connection as far as possible. While holding the tubing, tighten the fitting.
Turn the water on at the shutoff valve
Tighten any connections that leak.
Plug In the Refrigerator
Arrange the coil of copper tubing behind the refrigerator so it does not vibrate against the back of the refrigerator or against the wall. Push the refrigerator back to the wall.
Start the lcemaker
Set the icemaker switch to the ON position The icemaker will not begin to operate until it reaches its operating temperature of 15 °F
10
