Installation
Connect the Tubing to Water Line
1.Unplug refrigerator or disconnect power.
2.Turn OFF main water supply. Turn on the nearest faucet to relieve the pressure on the line. It may help to open an outside faucet to allow the water to drain from the line in the house.
3.Find a
NOTE
•Horizontal pipe will work, but the following precaution must be taken: Drill on the top of the pipe, not the bottom. This will help keep water away from the drill. This also keeps normal sediment from collecting in the valve.
4.To determine the length of copper tubing you will need, measure from the connection on the lower left rear of the refrigerator to the water pipe. Add 7 feet (2.1m) to allow for moving refrigerator for cleaning. Use
5.Using a drill, drill a
6.Fasten
7.Slip compression sleeve and compression nut on copper tubing as shown. Insert end of tubing into outlet end squarely as far as it will go. Screw compression nut onto outlet end with adjustable wrench. Do not over tighten.
8.Place the free end of the tubing into a container or sink, and turn ON main water supply and flush out tubing until water is clear. Turn OFF shutoff valve on the water pipe. Coil the copper tubing as shown belCoilw.
PackingNut |
| ColdWterPipe |
| PipeClamp | |
ShutOffValve |
| ofPolyethyleneor |
CompressionNut | pperTubing | |
CompressionSleeve |
|
9