Freezer
Compartment
Lamp
Dispenser Lamp
Care and Maintenance
How to Dismantle Parts
NOTE
•Dismantling is done in the reverse sequence of assembly.
Be sure to unplug the power plug before dismantling and assembly. Never apply severe force to dismantle parts. Parts may be damaged.
Remone cover by pressing upward on bottom | 2 | 1 |
and rotating outward . |
| |
Turn the bulb counterclockwise. Max. 40 W bulb |
| |
for refrigerator is used and can be purchased at |
|
a service center.
Seperate the lamp by pulling it out, and then remove the lamp. Max. 15 W bulb for refrigerator is used and can be purchased at a service center.
Freezer | To remove a shelf, Lift the left part of the |
Compartment | shelf a bit. Lift it to the direction , push the |
Shelf | right part to the direction , and take it out. |
Door Rack and Support
Ice Storage Bin
After Dispenser Is Used
Lift the door rack holding both sides and pull it out to direction.
Lift the ice shelf as shown in the right figure and pull it out .
Hold the ice storage bin as shown in the right figure and pull it out ➃ while slightly lifting it ➂.
It is recommended not to dismantle the ice storage bin unless it is necessary.
Use both hands to remove the ice bin to avoid dropping it.
If the ice bin does not slide into place easily, twist the drive device slightly.
The water collector has no
2
431
22