![](/images/new-backgrounds/1013701/1370135x1.webp)
Operating Instructions
Forced operation
Forced operation is used when the remote controller can't be used. The operation will be started if the ON/OFF button is pressed. If you want to stop the operation,
ON/OFF
button
| Cooling Model |
| Heat pump Model |
|
|
|
|
| |
| Room Temp. ≥ 24°C(75.2°F) | 21°C(69.8°F) ≤ Room Temp. < 24°C(75.2°F) | Room Temp. < 21°C(69.8°F) | |
|
| |||
|
|
|
|
|
Operating mode | Cooling | Cooling | Healthy Dehumidification | Heating |
|
|
|
|
|
Indoor FAN Speed | High | High | High | High |
|
|
|
|
|
Setting Temperature | 22°C(71.6°F) | 22°C(71.6°F) | 23°C(73.4°F) | 24°C(75.2°F) |
|
|
|
|
|
Test operation
During the TEST OPERATION, the unit operates in cooling mode at high speed fan, regardless of room temperature and resets in 18 minutes. During test operation, if remote controller signal is received, the unit operates as remote controller
sets. If you want to use this operation, Press and hold the ON/OFF button for 3~5 seconds, then the buzzer sound 1 'beep'. If you want to stop the operation,
NOTE
If you do not have the remote controller around here, you can start to operate the forced operation. If you force to close the front panel, some parts may be damaged.
Auto Restart Function
This function is useful in the situation of power failure.
When power regains after a failure this feature restore the previous operating condition
and the air conditioner will run in the same settings.
NOTE
This feature is enabled by factory default setting, but you can disable it by pressing the ON/OFF button for 6 seconds. The unit will beep twice and the lamp will blink 6 times.
To enable it, press the button again for 6 seconds. The unit will beep twice and the blue lamp will blink 4 times.
ON/OFF
button
18Air Conditioner