![](/images/new-backgrounds/1010509/1050929x1.webp)
Installation
Installation
Remove packing sheet from the back of the sleeve, and packing corner and blue tape from the air conditioner.
INSTALLATION REQUIREMENTS
If you use an existing wall sleeve, you should measure its dimensions.
Install the new air conditioner according to these installation instructions to achieve the best performance. All wall sleeves used to mount the new air conditioner must be in good structural condition and have a rear grille to securely attach the new air conditioner. (FIG. 1)
With the LGE sleeve, you can maintain the best performance of the new air conditioner. (FIG. 2)
INSTALLATION HARDWARE
1 |
| 2 |
|
| 4 |
|
| 2 Size options |
| 7 | 5 |
|
| |
8 |
| 3 |
|
| 6 |
|
| 2 Size options |
ENGLISH
(499 mm)
Air Conditioner
(626 mm)
(366 mm)
18"(458 mm)
FIG. 1
ITEM | NAME OF PARTS | Q'TY |
1 | PLASTIC GRILLE | 1 |
2 | HORIZONTAL INSULATION STRIPS | 2 |
3 | AROUND INSULATION STRIPS | 2 |
4 | SUPPORT BLOCK | 2 |
5 | BAFFLE | 1 |
6 | TRIM FRAME | 2 |
7 | SHIM | 2 |
8 | PLASTIC NUTS AND WASHER SCREWS | 4 |
7822
Expanded
aluminum metal grille
(656 mm)
(394 mm)
(425 mm)
CAUTION: To avoid risk of personal injury, property damage, or product
damage due to the weight of this device and sharp edges that may be exposed:
• Air conditioners covered in this manual pose an |
excessive weight hazard. Two or more people are |
needed to move and install the unit. |
To prevent injury or strain, use proper lifting and |
carrying techniques when moving unit. |
• Carefully inspect location where air conditioner will |
(877) 454-
LGE Wall Sleeve | FIG. 2 |
ELECTRICAL SERVICE
Check your available electrical service. The power supply available must be the same as that shown on the unit nameplate (found on left side of cabinet).
All models are equipped with a
be installed. Be sure it will support the weight of |
the unit over an extended period of time. |
• Handle air conditioner with care. Wear protective |
gloves whenever lifting or carrying the unit. AVOID |
the sharp metal fins of front and rear coils. |
• Make sure air conditioner does not fall during |
installation. |
REQUIRED TOOLS:
• Tight Fitting gloves | • | |
• Standard screwdriver | wrench or adjustable | |
wrench | ||
• Phillips screwdriver | ||
• | ||
• Pliers | ||
and ratchet | ||
• Sharp knife | • Tape measure | |
| • Electric drill | |
| • |
DIRECT SALES
Owner’s Manual 15