LG Electronics LW7000ER Remote Control Operations, Inserting the Remote Control Batteries

RemoteControl Operations

ENGLISH

1POWER

Operation starts when this button is pressed and stops when you press the button again.

2TEMPERATURE CONTROL

The thermostat monitors room temperature to maintain the desired temperature.

The thermostat can be set between 60°F~86°F (16°C~30°C).

The unit takes an average of 30 minutes to adjust the room temperature by 1°F.

3OPERATION MODE SELECTOR Select cooling mode to cool the room. Select energy saver mode for energy saving operation.

Select fan mode for basic ventilating fan operation. Select dry mode for dry operation.

4FAN SPEED SELECTOR

For increased power while cooling, select a higher fan speed.

3 steps: High ➔ Low ➔ Med

5ON/OFF TIMER

The timer can be set to start and stop the unit in hourly increments (up to 12 hours).

6REMOTE CONTROL SENSOR

7AIR PURIFIER

•Press the Air Purifier button. Operation will start when the button is pressed and stop when the button is pressed again.

•Set the fan speed again with the remote control. You can select the fan speed in three steps-high, low or medium.

Each time the button is pressed, the fan speed mode is shifted.

•If you press the only Air Purifier button, only air purifying operates without cooling.

Then, fan speed is low.

You can select the fan speed in three steps; high, low, or medium.

Each time the fan speed button is pressed, the fan speed mode is shifted.

8SLEEP MODE

•Press the sleep mode button to set the time you want the unit to turn off automatically.

•Every time you push this button, the remaining time will be set as follows. (1Hour → 2Hours → 3Hours → 4Hours → 5Hours → 6Hours → 7Hours → 0Hours → 1Hour → 2Hours → ...)

NOTICE : CLEAN FILTER

You can see "CLEAN FILTER" display after 1000 hours that it is the time of cleaning filter when operating in Air purifier.

AUTO RESTART

In failure of electric power, the unit runs as previous setting operation.

InsertingtheRemoteControlBatteries

1Push out the cover on the back of the remote control with your thumb

2 Pay attention to polarity and insert two new AAA 1.5V batteries.

3 Reattach the cover.

NOTICE : Do not use rechargeable batteries. Make sure that both batteries are new.

•In order to prevent discharge, remove the batteries from the remote control if the air conditioner is not going to be used for an extended period of time

Keep the remote control away from extremely hot or humid places.

To maintain optimal operation of the remote control, the remote sensor should not be exposed to direct sunlight.

• The remote control can be mounted on a wall using the mountable holder.

9