3.Operation
Setting the Clock
1.Press CLOCK.
(If the clock requires setting, press and hold CLOCK for more than 2 seconds.)
- The hours begin to flash.
2.Select a 12 hour cycle or 24 hour cycle by pressing TUNING (+/
(12HR) or (24HR)
3.Press SET to confirm the selected hour cycle.
4.Use TUNING
5.Press SET.
6.Use TUNING
7.Press SET and the correct time is shown on the display.
8.Press CLOCK at any time to display the time for about 3 seconds.
ote
The unit can also set the clock function in power off state.
Sleep Function
When the sleep timer is used, the power is auto- matically turned off after the specified time has elapsed.
1.To specify the time delay before the power is turned off, press SLEEP. In the display window you can see 
for about 5 seconds. This means that the system turns off automatically after 90 minutes.
Each time the button is pressed the time interval before it turns off is reduced by 10 minutes. i.e. 80...70... etc.
Select the desired time to turn off.
2.To check the remaining time until the power is turned off.
While the sleep function is active press SLEEP briefly. The time remaining until it turns off is displayed for about 5 seconds.
ote
If you press SLEEP while the sleep time is dis- played, the SLEEP time is reset.
To cancel the sleep timer mode
If you wish to stop the function, press the SLEEP button repeatedly until “SLEEP 10” appears, and then press SLEEP once again while “SLEEP 10” is displayed.
10
