LG Electronics RC199H Lock Parental Control Settings, Sampling Freq. Frequency, Rating

Sampling Freq. (Frequency)

If your receiver or amplifier is NOT capable of han- dling 96 kHz signals, select 48 kHz. When this choice is made, this unit automatically converts any 96 kHz signals to 48 kHz so your system can decode them.

If your receiver or amplifier is capable of handling 96 kHz signals, select 96 kHz. When this choice is made, this unit passes each type of signal through without any further processing.

Check the documentation for your amplifier to verify its capabilities.

DRC (Dynamic Range Control)

With the DVD format, you can hear a program’s soundtrack in the most accurate and realistic presen- tation possible, thanks to digital audio technology. However, you may wish to compress the dynamic range of the audio output (the difference between the loudest sounds and the quietest ones). This allows you to listen to a movie at a lower volume without los- ing clarity of sound. Set DRC to [ON] for this effect.

Lock (Parental Control) Settings

Rating

Blocks playback of rated DVDs based on their content. Not all discs are rated.

1. Select [Rating] option then press B.

2.To access the Rating, Password and Area Code features, you must input the 4-digit security code you created.

If you have not yet entered a security code you are prompted to do so. Input a 4-digit code. Enter it again to verify. If you make a mistake press CLEAR.

3. Select a rating from 1 to 8 using the v / V buttons.

[1]-[8] :Rating one (1) has the most restrictions and rating eight (8) is the least restrictive.

[No Limit] : If you select [No Limit], parental control is not active and the disc plays in full.

4.Press ENTER to confirm your rating selection, then press HOME to exit the menu.

Note:

If you set a rating for the recorder, all disc scenes with the same rating or lower are played. Higher rated scenes are not played unless an alternate scene is available on the disc. The alternative must have the same rating or a lower one. If no suitable alternative is found, playback stops. You must enter the 4-digit password or change the rating level in order to play the disc.

Set Password

You can enter or change password.

1.Select [Set Password] option then press B.

2.Follow step 2 as shown [Rating].

To change the password, select the [Change], press ENTER and input the new 4-digit code. Input it again to verify.

3.Press HOME to exit the menu.

If you forget your password

If you forget your password you can clear it using the following steps:

1.Press HOME and the Home menu appears.

2.Select [Setup] > [Start] and press ENTER.

3.Input the 6-digit number [210499]. The message appears, select [OK] then press ENTER. The security code is cleared.

4.Enter a new code as described above.

Area Code

Enter the Area Code whose standards were used to rate the DVD video disc, based on the list in the reference chapter (see page 52).

1.Select [Area Code] option then press B.

2.Follow step 2 as shown [Rating].

3.Select the first character using v / V buttons.

4.Shift the cursor using B buttons and select the second character using v / V buttons.

5.Press ENTER to confirm your area code selection, then press HOME to exit the menu.

HOOKUP AND SETTINGS

23