Troubleshooting
Check the following guide for the possible cause of a problem before contacting service.
Symptom | Cause | Correction | |
|
|
| |
No power. | The power cord is disconnected. | Plug the power cord into the wall out- | |
|
| let securely. | |
|
|
| |
Abnormal or no picture. | The TV is not set to receive Recorder | Select the appropriate video input | |
| signal output. | mode on the TV so the picture from | |
|
| the Recorder appears on the TV | |
|
| screen. | |
|
|
| |
| The video cable is not connected | Connect the video cable into the jacks | |
| securely. | securely. | |
|
|
| |
| Unit output setting and TV resolution | Check TV capability. | |
| capabilites mismatch. | Check mode of connections | |
|
| ||
|
| (eg. | |
|
| Check unit Resolution setting | |
|
| according to TV capability and mode | |
|
| of connection. | |
|
|
| |
| Wrong connection. | Check the connection. | |
|
|
| |
No sound. | The equipment connected with the | Select the correct input mode of the | |
| audio cable is not set to receive | audio receiver so you can listen to the | |
| Recorder signal output. | sound from the Recorder. | |
|
|
| |
| The audio cables are not connected | Connect the audio cable into the jacks | |
| securely. | securely. | |
|
|
| |
| The power of the equipment connected | Turn on the equipment connected with | |
| with the audio cable is turned off. | the audio cable. | |
|
|
| |
| The AUDIO options are set to the wrong | Set the AUDIO options to the correct | |
| position. | position. | |
|
|
| |
| In HDMI mode, audio selection is not | Change AUDIO setup to PCM mode. | |
| set to PCM. |
| |
|
|
| |
The playback picture is | The disc is dirty. | Clean the disc. | |
poor. |
|
| |
The TV channels are not tuned in properly. | Check tuning, carry out tuning again. | ||
| |||
|
|
| |
| Tape heads are dirty. | Clean video heads. | |
|
|
| |
| Tape is a rental or was recorded on | Use CH/TRK (v/V) for manual tracking | |
| another VCR. | adjustment while tape is playing. | |
|
|
| |
Picture from external | The video signal from the external | You cannot connect via the Recorder. | |
input is distorted. | component is | Connect the component directly to | |
|
| your TV. | |
|
|
| |
Some channels are | The skipped channels were deleted with | Use the CH. Add/Del feature to | |
skipped over when | the CH. Add/Del feature. | restore channels. See [To Add or | |
using CH(v / V). |
| Erase Channels] on page 21. | |
|
|
|
INTRODUCTION |
|
|
|
|
|
HOOKUP AND | SETTINGS |
|
|
|
|
PLAYBACK |
|
|
|
|
|
RECORDING |
|
|
|
|
|
EDITTING |
|
|
|
|
|
REFERENCE |
|
|
|
|
|
53
