EZ-Manager Wizard (Cont.)

Configure Pro:Centric Settings

Once you select “Next” from the TV Configuration Options screen, the Searching for Pro:Centric Server screen is displayed (see example at right), and you have the following options:

•You can allow the EZ-Manager Wizard to proceed with a series of automated steps to configure the STB for Pro:Centric operation and then to look for the Pro:Centric application and maintenance (E-Z Installation) files to download. In this case, the wizard uses a search algorithm to determine the Data Channel and the Pro:Centric Application Mode to set in the STB.

Continue with the “Automated Pro:Centric Configuration” sub- section below.

•If you already know the settings (i.e., Data Channel and

Pro:Centric Application Mode) that need to be configured in order for the STB to connect to the Pro:Centric server and/or if the Pro:Centric server is not yet installed, you may expedite the setup process by entering this data manually.

Continue with the “Manual Pro:Centric Configuration” subsection on the following page.

Automated Pro:Centric Configuration

Note: If the server is not yet configured on the system, use the manual configuration option to configure the Pro:Centric operation. See also note below.

Note: If Pro:Centric data delivery will be over IP and there is a DNS server at the site, you can create a “procentric.local” DNS entry for the Pro:Centric server that will enable automated Pro:Centric IP configuration via the EZ-Manager. If there is no DNS entry for procentric.local, you must use the manual configuration option to configure the Pro:Centric IP operation.

Once the Pro:Centric data channel is found (the Pro:Centric Server Was Found screen will be displayed—see example at right) and the Pro:Centric Application Mode is determined, the wizard will advance to the Processing the Pro:Centric Configuration screen, which shows the progress of the data downloads. Note that some steps may require a few minutes.

If the process is successful, no further user interaction is required, though, in some instances, where the option (for example “Next”) is available, you may manually move forward to subsequent steps within the wizard to speed up the process.

EZ-Manager Wizard

1 2 3 4

Searching for Pro:Centric Server...

It may take 1 min 32 second(s).

This step automatically searches for the Pro:Centric server.

If there is no Pro:Centric Server installed, you do not need to continue with this procedure. Please select either ‘Exit’ or ‘Manual Pro:Centric’.

Status : Tuning channel 49

TV is now searching all of the channels for the data channel...

Back

 

Exit

 

Manual Pro:Centric

 

 

 

 

 

Note: You can select the “Back” button, where available, to check previous settings, as necessary.

EZ-Manager Wizard

1 2 3 4

Pro:Centric Server was found...

It may take 2 second(s).

The Pro:Centric data channel was found!! (Data Channel: 75, Mode: GEM) The Download window will open in 2 second(s). You may wait or select ‘Next’. Otherwise, if you select ‘Exit’, the Pro:Centric server settings can be retained and used during the next download by selecting ‘Save & Exit’ in the Exit window.

Status : Tuning channel 75

The Pro:Centric data channel is found!! (Data Channel: 75, Mode: GEM)

Back

 

Exit

 

Next

EZ-Manager Wizard

1 2 3 4

Processing the Pro:Centric Configuration...

Downloading the maintenance files takes several minutes.

Please wait...

 

20%

 

 

 

Retrieving files from data channel 75

Application files

GEM app downloaded

Maintenance files

In progress...

– Updating Configuration File

Warning - Do not remove AC power or the signal cables during these steps

(Continued on next page)

206-4256

19