Lide Glass Lid 3500P, 3502, J3500 STOVE CONTROLS, left view, Front view, Side view showing control operation

STOVE CONTROLS

Front view

Adjustable Air Deflector
Move up or down to
				Sliding heat exchanger tube cleaning
adjust air direction
				rod. Pull in and out to clean heat
				exchanger tubes.
	Adjustable Door Handle
				Adjustable hinges. Loosen locking
	lifts up and turns to the left
				nut and move in or out to adjust.
	to open
				Ash Pan (3502 models only)
	Ash clean outs (3500P & 3500L
	model) Pull out to empty ashes
	out of firebox area and back heat		Pedestal Ash Pan (3500P & 3500L
	exchanger area. Make sure to		models)
	push all the way in when done.		Pull out to empty ash pan. Make sure
			that the ash pan is up against the seal
		left view	on the pedestal when in place.
				There is a scraper provided with the
				unit for cleaning out the ash. There is
	Left Side			a hole in one end for hooking onto the
				front heat exchanger tube rod for

cleaning if the unit is hot.

Circuit Board control panel.

Open door and select heat and fuel stirrer settings.

Manual Draft Adjustment control knob. Slide in or out to decrease or increase draft

If you want to, you can purchase an adhesive back hook and place it on the back panel of the unit to store the scraper tool. This can be purchased at any local hardware store.

Side view showing control operation

Adjustable Air Deflector

Slide Heat Exchanger Tube cleaning rod in and out to clean tubes

shown pulled out

Ash Cleanouts located on the left and right side of the front of unit. Slide out for cleaning. (3500P & 3500L models) shown pulled out

22