DRAFT SLIDE GATE ADJUSTMENT

Draft Slide

Gate

# 10 bolt with 5/16 hex head

Exhaust Draft Motor located inside of Left side panel

NOTE: Always disconnect power before making this adjustment.

The normal operation of the Countryside would be with the Draft Slide Gate open fully as shown. When the gate is in the fully open position, the plate will be against the mounting plate as shown.

If the unit needs a draft correction adjustment, the bolts are loosened and the slide gate is rotated a few degrees at a time until the proper operation of the unit is achieved.

NOTE: This adjustment must be made by a qualified Countryside installer

When rotating the slide gate, be careful not to damage the gasket. Re-tighten the bolts and check for leakes.

37