Liebert MP-C5120 Configuration With Liebert Mp Advanced Access Server, Make Connections

CONFIGURATION WITH LIEBERT MP ADVANCED ACCESS SERVER

Liebert MP Advanced

Power Strip

(MP-C5120)

EIA-232 Port - Connect

to Power Strip EIA-232 Port

Liebert MP Advanced	Ethernet Port
Access Server
(MP-S5138)

Mounting Bracket on either side

POWER 1	3	5	8	EIA-232	EIA-232 Port
2	4	6	8

MP-DS74 Card With

Configurable

Communication Ports

EIA-232			ETHERNET	DS62 NETWORK INTERFACE	CX4 EIA-232 I/0					CX1CX2	DS74
					CX3
	ROUTE	LINE				4	3	2	1

100-240VAC

??????????

0.21-0.

MADE IN USA

On/Off Switch (not on all Access Servers)

MAKE CONNECTIONS

1.Connect power to the Liebert MP Advanced Access Server and turn the unit On (the On/Off switch is on the rear of the unit; some units do not have this switch; they are energized whenever their power cord is plugged into a power source).

2.Attach the adapter (RS-232 to RJ-45) to one end of a silver configuration cable (included) and connect that end of the cable to a COM port on a computer. Connect the other end of the cable to the EIA-232 port of the MP-DS62 card on your MP Advanced Access Server.

3.Plug one end of the second silver RJ-45 cable into any of the ports in the MP-DS74 module in your Liebert MP Advanced Access Server; plug the other end of the cable into the EIA-232 port on your MP Advanced Power Strip.

ESTABLISH COMMUNICATION WITH CARD

1.Use terminal emulation software, such as HyperTerminal™, to open a direct connection to the MP-DS62 card. Use the settings at right. Press Enter for the Main Menu, choose “C” and then “1” to configure the MP-DS62 port.

2.Enter “8” for Network Port Configuration (below left), then “7,” then “N” to disable DHCP (below right).

HYPERTERMINAL SETTINGS

Baud Rate: 9600

Data Bits: 8

Parity: None

Stop Bits: 1

Flow Control: N/A

		Enter “N”
	Enter “7”	to disable
Choose “8” to change		DHCP
Network Port	to change
	DHCP setting
Configuration

3