SET THE IP ADDRESS
1.Select “1” to set the IP Address for Module 1. Enter an IP address (below). The address must be unique on your system (obtain this from your network administrator).
2.Press Enter to return to the Network Port Configuration menu.
Enter IP address
3. Choose “2” to set the Subnet Mask for your system (obtain this from your network administrator).
SET THE GATEWAY ADDRESS
1.Return to the Network Port Configuration menu and choose “3” to set the Gateway Address (the IP address of your network router). Follow the prompts to exit HyperTerminal and save your changes.
2.Verify that your settings are correct and were saved by using a command prompt to ping the
3.At the command prompt enter:
ping [IP address]
4. Press “Enter.”
Liebert Corporation
1050 Dearborn Drive | Telephone: |
P.O. Box 29186 | Facsimile: |
Columbus, OH 43229 | www.liebert.com |
© 2005 Liebert Corporation
All rights reserved throughout the world. Specifications subject to change without notice.
®Liebert and the Liebert logo are registered trademarks of Liebert Corporation. All names referred to are trademarks or registered trademarks of their respective owners.
4
