Setup mode

The following functions can be activated in setup mode: = Child lock

= Confirm water filter change

= Ice maker holiday mode

= Water quantity for ice-cube tray

= Display brightness

= Door gasket heating control = Confirm dust filter cleaning

Activating setup mode:

• Touch the SuperFrost icon for 5 seconds.

-The SuperFrost LED comes on for 5 seconds,

-after 5 seconds will flash in the display.

The appliance is in setup mode now.

You can select the setup mode functions by touching the freezer compartment temperature setting icons.

Note: In setup mode the display will flash continuously.

Exiting setup mode:

• Touch the freezer compartment On/Off icon

The appliance will change back to normal operation.

= Child lock

The child lock is designed to protect the appliance from being switched off accidentally.

Activating the child lock

Activate setup mode by touching the SuperFrost icon for 5 seconds.

- The display reads

• Touch the SuperFrost icon.

- The display reads

• Touch the SuperFrost icon again.

- The LED is lit and the child lock is activated.

• Exit setup mode by touching the freezer compartment On/Off icon.

Deactivating the child lock

Activate setup mode by touching the SuperFrost icon for 5 seconds.

- The display reads

• Touch the SuperFrost icon.

- The display reads

• Touch the SuperFrost icon again.

- The LED goes out. The child lock is deactivated.

• Exit setup mode by touching

the freezer compartment On/Off icon.

= Confirm water filter change

Afterthe water filter has beenchanged,the drop symbol on the display must be reset.

Resetting the drop symbol

• Activate setup mode by touching the ­SuperFrost icon for 5 seconds.

Touch the freezer compartment Down icon until appears in the display.

• Touch the SuperFrost icon. - The display reads

Touch the SuperFrost icon again. - The display reads

The drop symbol disappears.

• Exit setup mode by touching the freezer compartment On/Off icon.

= Ice maker holiday mode

See section entitled "Ice maker".

= Water quantity for ice-cube tray

If the produced ice cubes of the ice maker are too small, the inflow- ing water quantity can be adjusted.

Adjusting the water quantity

Activate setup mode by touching the SuperFrost icon for 5 sec- onds.

Touch the freezer compartment Down icon until appears in the display.

Touch the SuperFrost icon.

-The display reads

Touch the freezer compartment Up icon once only so that E4 appears in the display.

Caution!

Do not increase for more than one step. If the adjusted value is too high, the icecube tray of the ice maker could overflow.

Touch the SuperFrost icon again.

Exit setup mode by touching the freezer compartment On/Off icon.

Check the ice cube size within the next days. If the ice cubes are still too small, follow the steps above again.

16

Page 6
Image 6
Liebherr 7082 135-00 manual Setup mode, = Child lock, = Confirm water filter change, = Ice maker holiday mode