Liebherr 7082 260-00 manual Instructions for installation and modification, Dimensions, 56,5

Instructions for installation and modification

Dimensions

The external dimensions of the appliance can be seen on fig. S and in the table below.

Gross capacity of appliance (l)Height H (mm) (see type plate)

188	(20..)	1250
233	(24..)	1447
279	(29..)	1644
324	(33..)	1841

Installation instructions

- Do not install models without side-wall heating side-by- side with another refrigerator or freezer. This is important to prevent condensation and consequential damage from it.

- Models with side-wall heating are designed for side-by- side installation; they are designed for combination with a refrigerator.

Contact your dealer for more information.

-Attachment instructions are supplied in the accessories bag of the appliance with side-wall heating.

Changing over door hinges

The door hinges can be changed from one side to the other if required.

WWith the door open, lever out plinth panel 1 on the hinge side with a screwdriver and remove from front.

-Lever out cover 2 with a screwdriver. Close door.

-Unscrew screw M5 3.

WPull hinge component 4 with hinge pin 5 out from un- derneath and remove.

WOpen door, lift out at bottom and remove; do not lose the spacer 6.

WTransfer all hinge components onto the other side:

-Lever out covers 8 with a screwdriver at the front and remove at an angle from below. Remove hinge pin 7 and insert on the opposite side. Use the hexagon socket on the open-ended spanner provided (spanner width 5). Fit covers 8 again: insert at rear and click into place at front.

-Bottom: Using a screwdriver, remove the spacer 9 and replace on the other side.

WRe-attach the door:

-Remove plugs bo from the door mounting points and replace on the other side.

-Suspend door with spacer 6 in hinge pin 7, close door.

-Rotate hinge component 4 by 180°, remove hinge pin 5, turn by 180° and replace. Mount both parts in the hinge bp: slide the pin into the door mounting through the hinge, tilt in the hinge component, slide up and attach with screw 3.

WAlign the door flush with the body of the appliance using the slot on the hinge bp, then tighten screw 3.

WAttach the plinth panel 1 and click into place by press- ing.

WWith the door open, insert the cover 2 in the plinth panel at the front and click into place at the back.

WTransfer* door handle bl and plugs bm: With the door open, carefully lift out the pressure plates* bn at the front and slide away; unscrew handle.

Reassemble in reverse order: replace the pressure plates and click into position.

[mm]	660	683
		662
	704		1287
H
S	56,5			10
	8		13
	7
8	SW5	12*	10*	11 *
	6
		Torx	15
	9
2	5
	4
		3
14
	9
14	1
T	T1

_____________________________________________________

All types and models are subject to continuous improve- ment and the manufacturer therefore reserves the right to make modifications in the shape, equipment and technolo- gy.

GNP..6 21