ICEMAKER
To Start the IceMaker - Figure 11
The IceMaker will only work if the combined
The IceMaker is in the top left drawer in the freezer compartment of the combined
To turn on
•Pull out the drawer.
•Press the “ON/OFF” button so the control lamp comes on (Figure 11).
•Close the drawer.
Note
The icemaker can only make ice cubes if the drawer is completely closed.
Figure 11
To turn off
If you do not need any ice cubes, the icemaker can be turned off independently of the freezer compartment.
•Press the “ON/OFF” button for approximately 1 second so the control lamp goes out.
Note
If the icemaker is turned off, the empty drawer can also be used to freeze and store food.
The production capacity depends on the temperature inside the freezer compartment. The lower the temperature, the more ice can be produced over a period of time.
The ice cubes fall out of the icemaker into the drawer. When the ice reaches a certain level in the drawer, the appliance stops producing ice automatically.
If you need a large quantity of ice you can change out the drawer to the right with the complete “IceMaker” drawer. When you close the drawer the icemaker will immediately start production.
To Clean the IceMaker - Figure 12
The IceMaker (arrow in Figure 12) can be cleaned by using this procedure.
1.Pull out the drawer and remove the ice.
2.Clean the drawer with warm water and mild dish detergent.
3.To access the IceMaker for cleaning:
a.With the drawer pulled out, press and hold the “ON/OFF” button until the LED goes out (takes about 1 second).
b.Continue to hold the button and after 10 seconds the LED will start to flash.
c.Insert the drawer while the LED is flashing. The IceMaker should rotate down into the cleaning position.
d.Remove the drawer.
4.Clean the IceMaker with warm water. If you need to use a cleaning aid, use a mild dish detergent and rinse. You will need to throw out the first three batches of ice if you use any soap.
5.Push the “ON/OFF” button until the LED lights and insert the drawer.
6.Throw out the first three batches of ice to remove any soap residue.
Note
If you need to leave the IceMaker off, clean the IceMaker but do not push the “ON/OFF” button in Step 5.
To make ice cubes
After you start the icemaker for the first time it may take up to 24 hours before the first ice cubes are ready.
Note
The first three batches of ice must not be consumed or used.
Figure 12
* Depending on model and options
BFI/BF1055 (7082 | 15 |
