Instructions for installation and modification
Dimensions |
|
|
The external dimensions of the appliance can be seen on fig. | ||
S and in the table below. |
| |
Gross capacity of appliance (l) | Height H (mm) | |
(see type plate) |
| |
___________________________________________________ | ||
188 | (20..) | 1250 |
233 | (24..) | 1447 |
279 | (29..) | 1644 |
324 | (33..) | 1841 |
Installation instructions
Do not install the appliance
Changing over door hinges
The door hinges can be changed from one side to the other if required.
W With the door open, lever out plinth panel 1 on the hinge side with a screwdriver and remove from front.
- Lever out cover 2 with a screwdriver. Close door.
- Unscrew screw M5 3.
W Pull hinge component 4 with hinge pin 5 out from under- neath and remove.
W Open door, lift out at bottom and remove; do not lose the spacer 6.
W Transfer all hinge components onto the other side:
- Lever out covers 8 with a screwdriver at the front and remove at an angle from below. Remove hinge pin 7 and insert on the opposite side. Use the hexagon
socket on the
- Bottom: Using a screwdriver, remove the spacer 9 and replace on the other side.
W
- Remove plugs bo from the door mounting points and re- place on the other side.
- Suspend door with spacer 6in hinge pin 7, close door.
- Rotate hinge component 4 by 180°, remove hinge pin 5, turn by 180° and replace. Mount both parts in the hinge bp: slide the pin into the door mounting through the hinge, tilt in the hinge component, slide up and attach with screw 3.
W Align the door flush with the body of the appliance using the slot on the hinge bp, then tighten screw 3.
W Attach the plinth panel 1and click into place by
the front and click into place at the back.
W Transfer* door handle bl and plugs bm: With the door open, carefully lift out the pressure plates* bn at the front and slide away; unscrew handle.
Reassemble in reverse order: replace the pressure plates and click into position.
[mm] | 660 | 683 |
| |
| 662 |
|
| |
|
|
|
| GB |
| 704 | 1287 |
| |
|
|
|
| |
H |
|
|
|
|
S | 56,5 |
| 10 |
|
| 8 |
| 13 |
|
| 7 |
|
|
|
8 | SW5 |
| 11 | * |
|
|
| ||
|
|
|
| |
| 6 | 12* | 10* |
|
|
|
|
| |
|
| Torx | 15 |
|
| 9 |
|
|
|
2 | 5 |
|
|
|
|
|
|
| |
| 4 |
|
|
|
|
| 3 |
|
|
14 |
|
|
|
|
| 9 |
|
|
|
14 | 1 |
|
|
|
|
|
|
| |
T | T1 |
|
|
|
________________________________________________ |
All types and models are subject to continuous improvement and the manufacturer therefore reserves the right to make modifications in the shape, equipment and technology.
GNP..06 | * Depending on model and options | 21 |