Putting into operation
WARNING
Fire hazard due to refrigerant!
The refrigerant R 600a is environmentally friendly but flam- mable. Escaping refrigerant may ignite.
u Do not damage the piping of the refrigeration circuit.
WARNING
Fire hazard and danger of damage!
u Do not place appliances emitting heat e.g. microwaves, toasters etc. on the appliance!
WARNING
Blocked ventilation openings pose a risk of fire and damage! u Always keep the ventilation openings clear. Always ensure
that the appliance is properly ventilated!
NOTICE
Risk of damage due to condensate!
u Do not install the appliance directly alongside a further refrigerator/freezer.
q In the event that the appliance is damaged, contact the supplier immediately before connecting to the mains.
q The floor at the site must be flat and level.
q Do not install the appliance in a location where it is exposed to direct radiation of the sun, next to a cooker, heater and similar.
q Always stand the appliance with its back directly to the wall. q The appliance may be moved only when it is empty.
q Do not install the appliance without assistance.
q Standard EN 378 specifies that the room in which you install your appliance must have a volume of 1 m2 per 8 g of R 600a refrigerant used in the appliance. If the room in which the appliance is installed is too small, a flammable
u Detach the connecting cable from the rear of the appliance, removing the cable holder at the same time because other- wise there will be vibratory noise!
NOTICE
The stainless steel doors are finished with a high quality surface coating and must not be treated with the enclosed care product,
as otherwise the surface coating will be damaged.
u Please only use a soft clean cloth to wipe the coated door
surfaces.
u Only use a stainless steel care product on the stainless steel side walls, applying it evenly in the direction of polishing. Subsequent cleaning will then be easier.
u Use only a soft clean cloth to wipe side walls and door surfaces with a paint finish.
uRemove the protective film from the decorative trims.
uRemove all transit supports.
uDispose of packaging material (see 4.5) .
u Align the appliance so that it stands firmly and on a level by applying the accompanying spanner to the adjustable- height feet (A) and using a spirit level.
Note
u Clean the appliance (see 6.2) .
If the appliance is installed in a very damp environment, condensate may form on the outside of the appliance.
u Always see to good ventilation at the installation site.
4.3 Changing the door stop
You can change over the door hinges if necessary. Make sure that the following tools are to hand:
q Torx® 25
q Torx® 20
q Torx® 15 q Screwdriver
q Supplied
q If necessary, a second person to assist with installation
CAUTION
Risk of injury if the door tips! u Take good hold of the door. u Set down the door carefully.
5
