Liebherr CS 1601 II. Electrical Requirements & Safety, III. IceMaker if equipped, General Remarks

Models: CS 1601 CS 1650 SBS 32S0

1 22
Download 22 pages 37.4 Kb
Page 8
Image 8
II. Electrical Requirements & Safety

General Remarks

II. Electrical Requirements & Safety

A 115 Volt, 60 Hz, 15 Amp (20 Amp for side-by-side installation) fused electrical supply is required. Connect undercounter wine cabinet to a 115 VAC, 10 amp (15 Amp for side-by-side installations) circuit that is con- trolled by a circuit breaker or fuse.

We recommend using a dedicated circuit for these ap- pliances to prevent electrical overload. Comply with the National Electrical Code as well as local codes and ordinances when installing the receptacle.

The power cord is equipped with a three-prong (ground- ing) plug for your protection against possible shock hazards. To maintain this protection:

Do not modify the plug by removing the round ground- ing prong.

Do not use a power cord that is frayed or damaged.

Do not ground to a gas pipe. Check with a qualified electrician if you are not sure the appliance is properly grounded. Do not have a fuse in the neutral or grounding circuit.

ELECTROCUTION HAZARD Electrical Grounding Required. This appliance is equipped with a three- prong(grounding) polarized plug for your protection against possible shock hazards.

DO NOT remove the round grounding prong from the plug.

DO NOT use a two-prong grounding adapter.

DO NOT use an extension cord to connect power to the unit.

III. IceMaker (if equipped)

The icemaker is located in the freezer compartment. It must be connected to the water supply to function properly. The appliance must be level for the icemaker to function properly.

The water pressure must be between 21.8-87.0 psi (1.5-6 bar). Use a 1/4" OD copper line to connect the water supply to the solenoid valve. This is not supplied with the refrigera- tor.

If you have hard water, we recommend you install a water softener. Also, a filter must be installed if the water contains solids such as sand. All equipment and devices used to supply the water to the appliance must comply with the current regulations for your geographical area.

Safety Instructions and Warnings

Do not attach the water source while the appliance is connected to an electrical outlet.

A shut-off valve, must be installed between the hose line and the main water supply so that the water sup- ply can be stopped if necessary. Do not install the shut-off valve behind the refrigeration unit.

The connection to the water supply may only be made by a trained and licensed plumber.

The water quality must comply with the drinking water regulations for the geographical area where the appli- ance is located.

The icemaker is designed exclusively to make ice cubes in quantities needed by a household and may only be operated with water appropriate for this pur- pose.

All repairs and work on the icemaker may only be done by customer service personnel or other trained person- nel.

The manufacturer cannot accept liability for damage caused by equipment or water lines between the sole- noid valve and the water supply.

Page 8
Image 8
Liebherr CS 1601 II. Electrical Requirements & Safety, III. IceMaker if equipped, DO NOT use a two-prong grounding adapter