Liebherr WFI1051, WF1051 manual Operation and Control Elements

Models: WF1051 WFI1051

1 19
Download 19 pages 39.99 Kb
Page 10
Image 10

OPERATION AND CONTROL ELEMENTS

12 10 9 8 7 6

 

41 °F

 

 

 

 

 

 

64

Up

Down

On/Off

SuperFrost

Alarm

On/Off Light Zone Up Down

 

 

 

 

 

 

- 0

 

 

 

 

 

13

1

 

2

3

4

5

Switching the appliance on and off

WTo switch on: Press the on/off buttons (bn on left for wine

cooler zone and 3 on right for freezer compartment) so that the temperature displays light up or flash.

-Freezer compartment: When the appliance is switched on for the first time and while it is still warm, the freezer display will contain dashes until the temperature falls below 32°F (0°C).

WTo switch off: Press the on/off buttons (bn on left for wine cooler zone and 3 on right for freezer compartment) for ap-

prox. one second so that the temperature displays go out.

-The freezer compartment can be operated without the wine cooler zone. However, if the freezer compartment is switched off, the entire appliance will be switched off.

Setting the temperature

The appliance is pre-set for normal operation. We recommend temperatures of 46°F (8°C) to 54°F (12°C) in the wine cooler zone and 0°F (-18°C) in the freezer.

WThe wine cooler zone is divided into two compartments whose temperatures can be adjusted independently of one another, according to your needs. To select a temperature zone, press button 9. The corresponding compartment will be shown in the display.

WTo reduce the temperature: Press the Down button; 8 on left for wine cooler zone and 2 on right for freezer.

WTo increase the temperature: Press the Up button.

- While you are entering the temperature, the set

41 °F

64

temperature will flash on the display.

- 0

-When you press the temperature setting buttons for the first time, the most recent setting (known as the "reference setting") is displayed.

-You can change the settings in increments of 1°F (1°C) by briefly pressing the buttons again. If the buttons are held down the temperature setting will change faster.

-Approximately 5 seconds after the button has been released, the display will automatically show the actual freezing or cooling temperature (known as the "actual setting").

-The altered temperature adjusts slowly to the new value. You can change the temperatures

W in the wine cooler zone:

between 64°F (18°C) and 41°F (5°C) and

W in the freezer:

between 7°F (-14°C) and -15°F (-26°C).

Whether you can obtain the lowest temperature depends on where the appliance is positioned (if it is located in an area with a high ambient temperature it will not reach the lowest temperature).

Temperature display

In normal operation, the following settings will be displayed:

-the average wine cooler temperature in display 7 and

-the warmest frozen food temperature in display 1.

The display will flash:

-if you change the temperature,

-if the wine cooler temperature is too low or

-if the temperature rises by several degrees, indicating cold loss, e.g. if you place fresh, "warm" food in the freezer or if you remove or re-pack frozen food the temperature may rise for a short time due to warm air flowing into the freezer. Once you have finished loading or re-packing, the electronics will automatically re-set the temperature to the most recent set- ting. Short-term rises in temperature will not affect the frozen food.

WIf "F0" to "F5" appears in the display, the appliance has a fault. Consult the customer service department indicating the fault number displayed as this will tell the technician what kind of irregularity has occurred.

Power failure/FrostControl display

If appears in the display, this means that the freezer temper- ature has risen too high during the last few hours or days due to a power failure.

WIf you press the alarm on/off button 5 whilst the display is reading , the highest temperature registered during the

power failure will be displayed.

Check the quality of the food and its suitability for consump- tion in case it has become too warm or even defrosted.

-The highest temperature will appear for approx. 1 minute. After that, the actual temperature in the freezer will re-ap- pear. The "highest temperature" display can be switched off

by pressing the alarm on/off button.

Once the power is re-instated, the appliance will continue to operate at the most recent temperature setting.

Audible alarm signal

The audible alarm signal helps to protect the stored wine and frozen food from excessive temperatures and to save energy.

WThe audible alarm signal is switched off by pressing the alarm on/off button 5.

-It switches off automatically as soon as the temperature is low enough or

-the door is closed.

Audible door alarm

-This sounds when the door has been left open for longer than about 60 seconds.

The sound switch-off function is active as long as the door is left open. The alarm automatically switches back to standby when the door is shut.

Audible/visual temperature alarm

It always sounds if

-the wine storage temperature is too high or too low or

-the freezer temperature is not low enough (dependent on the temperature setting).

The temperature display flashes at the same time.

This can be caused by:

-warm, fresh food being placed in the freezer;

-too much warm air from the outside entering when re-arrang- ing or removing frozen food.

The temperature display will continue to flash until the cause of the alarm has been rectified. It will then stop flashing and light up continually. The audible warning signal is now automatically reset.

A delight in freshness

6

WF1051 / WFI 1051

Page 10
Image 10
Liebherr WFI1051, WF1051 manual Operation and Control Elements

WF1051, WFI1051 specifications

The Liebherr WFI1051 and WF1051 are advanced refrigeration and freezing appliances designed to meet the needs of both professional kitchens and residential use. Renowned for their innovative features and robust construction, these appliances are perfect for preserving food quality and ensuring optimal storage conditions.

One of the standout features of the Liebherr WFI1051 and WF1051 is their high energy efficiency. Incorporating advanced cooling technologies, these models utilize a state-of-the-art compressor along with optimized insulation to minimize energy consumption. This not only reduces utility costs but also helps in promoting sustainable practices. Both units are equipped with an Energy Star rating, indicating their compliance with strict efficiency standards.

Temperature management is another critical aspect of the Liebherr WFI1051 and WF1051. The appliances feature precise electronic controls that allow users to easily set and monitor temperatures. With a temperature range that can be adjusted to suit different food preservation needs, these units ensure that perishable items are stored under ideal conditions. Additionally, they come with a powerful cooling system that maintains consistent temperatures, preventing fluctuation that can compromise food safety.

The Liebherr WFI1051 and WF1051 boast a sleek design, characterized by their stainless steel exteriors and ergonomic layouts. This modern aesthetic not only enhances the kitchen’s appearance but also makes cleaning and maintenance easier. The interior of both models is thoughtfully designed, offering ample shelving space that can be easily rearranged to accommodate various food items, from bulk packages to small containers.

Technology plays an essential role in the functionality of these units. Equipped with a user-friendly digital display, the Liebherr WFI1051 and WF1051 allow for straightforward operation, giving users instant access to essential information such as current temperature and diagnostic alerts. Integrated LED lighting illuminates the interior, enhancing visibility without generating excess heat.

Safety features are also a priority in the design of these appliances. Both models include a door alarm that alerts users if the door has been left ajar, thereby preventing temperature loss. Additionally, they are designed with a child lock feature, ensuring that settings are secure from unauthorized adjustments.

In summary, the Liebherr WFI1051 and WF1051 stand out for their combination of energy efficiency, innovative storage solutions, user-friendly technology, and modern design. These appliances are ideal for those seeking dependable, high-performance refrigeration solutions for their kitchen needs. Whether for commercial or domestic use, they provide the reliability and advanced features necessary for optimal food preservation.