Liebherr WFI1051, WF1051 manual Zone selection Labels, Setting the light to Dim mode

WINE COOLER ZONE

Zone selection	Labels
W The wine cooler zone is divided into two compart-	The appliance is supplied with
ments whose temperatures can be adjusted inde-	a label for each shelf. Use
pendently of one another, according to your needs.	these to label the type of wine
To select a temperature zone, press button 9. The	stored on each shelf. Use a
corresponding compartment will be shown in the display.	soft pencil on the labels so	B
Setting the light to Dim mode	that you can erase it again
	when necessary.
On glass door models, you can set the light to Dim mode us-	Additional labels can be obtained from your dealer.
ing the "Light" button bl. You can select the brightness of the
	W Insert the labels from above as illustrated in fi gure B.
interior light when the door of the wine cooler zone is closed.
W If the button is dark, the light becomes dimmer and dimmer
once the door has been closed and fi nally goes out.	Folding the wooden grid shelf
W To activate the Dim mode, press the "Light" button bl	Your appliance is equipped with a foldable wooden grid shelf
briefl y until it lights up.
	for each wine cooler compartment.
By pressing buttons bl and 8, you can determine the
	Use this option to safely store wine
brightness. To increase the brightness use bl and "Up" and
	bottles which have been opened.
to decrease the brightness use bl and "Down". Both wine
	To fold the wooden grid shelf, press
cooler compartments are activated at the same time.
	the catch under the cover strip to
	the side. The wooden grid shelf folds
	down.

!WARNING

DO NOT load more than 26.5 lb (12 kg) of products per shelf.

!CAUTION

Do not adjust a shelf with products on it. Failure to follow these instructions may re- sult in minor or moderate injury or damage.

Removing the wooden grid shelves

The foldable wooden grid shelf runs on pull-out rails. To remove the shelf,

lift it upwards from the pull-out rails and pull it out towards you. Ensure

that the shelf does not remain attached to the catch at the back. To insert, slide the shelf under the catch at the back and then press the shelf onto the rails until you hear it click

into place.

The lower wooden grid shelf can be removed as follows: Pull the shelf out towards you at an angle

and at the same time, lift it up. To insert, slide in the shelf above the stop

fi tted on the intervening shelves until it touches the rear wall and push down.

Replacing the activated charcoal filter

The way in which wines continue to mature depends on the ambient conditions. The quality of the air is therefore decisive for preserving the wine. To guarantee an optimal throughput of air, an activated charcoal fi lter is fi tted in each wine cooler compartment. Please refer to appliance overview for position, fi gure A.

We recommend that you replace the fi lter once a year. Filters can be obtained from your dealer.

Changing the filter:

WTake the fi lter by the handle. Turn it 90° to the left or right and remove.

WInserting the fi lter: Insert with the han- dle in a vertical position. Turn it 90° to the left or right until it clicks into place.

1

2

1

A delight in freshness

8 WF1051 / WFI 1051