STEP 16
•Screw the threaded end of CABLE (18) approximately 3/4” into the SWIVEL HOLDER (5) and tighten jam nut SECURELY as shown in FIGURE 16.
•SECURELY assemble one 1/2 X 3/4” BUTTON HEAD CAP SCREW (12) to the SWIVEL HOLDER (5). See FIGURE 16.
•Attach one 5/16” SNAP HOOK (24) and one STRAP (15) to the ball end of the CABLE (18). See FIGURE 16.
•Apply one set of WEIGHT STACK LABELS - LBS. OR
(40)to each WEIGHT PLATE (41) as shown in FIGURE 16.
•Insert the WEIGHT STACK PIN (21) into the first WEIGHT PLATE
(41)of the WEIGHT STACK as shown in FIGURE 16.
•If the HEAD PLATE (17) does not sit on top of the first WEIGHT PLATE (41), push the head plate down, insert the SELECTOR PIN
(21)and perform several repetitions on the machine. This will relax the cable system and prevent the HEAD PLATE (17) from lifting up.
•If after completing the previous step the HEAD PLATE (17) still does not sit on top of the first WEIGHT PLATE (41) or if there is excess slack in the cable system, adjust the threaded end of the CABLE (18) accordingly and RETIGHTEN the jam nut.
•Repeat STEPS
FIGURE 16 | |
| 1 2 |
| 5 |
1 5 | 2 4 |
| |
| 1 8 |
| 1 7 |
| 3 9 4 0 |
| 4 1 |
| 2 1 |
16 |
|
