Life Fitness 8973701 REV B-3 Plug in the Unit, Plug cables into the back of the display console

3.9CONNECT ALL CONSOLE WIRING; CONSOLE TO CONSOLE BRACKET; BACK PLASTIC SHELL

Parts: Hardware Bag #6 (4, M5 X12mm Black Phillips Screws) (6, M3.5 X 8mm Black Zinc Screws)

Tools: Phillips Screwdriver

Position the console (B1) close to the console bracket (C1) and follow the below instructions to connect all wiring.

Plug cables into the back of the display console:

1.Plug the 15-pin connector at the end of the upper wire harness into the 15-pin connector (15P) in the back of the display console. Make sure the connector snaps into place.

2Plug the 4-pin connector at the end of the contact heart rate sensor cable to the 4-pin cable (4P) located in the console.

3.Plug in the flat 13-pin connector for the Coach Zone.

4.Push excess cables into the opening of the upright tube assembly.

5.Plug the ground cable (green wire, single spade) from the product base to any of the three metal ground terminals (G) in the Go Console, or into the connector (G) leading from the back of the Track Console.

Line up the four holes in the console bracket with the four holes in the back of the display console. Attach the display console using four M5 X 12mm Black Phillips Screws (D1). Be careful not to pinch cables between the console and the console bracket. Be sure to get each screw started before fully tightening.

Note: To avoid stripping, do not overtighten the screws.

Attach the plastic shell (E1) that covers the steel bracket in the back of the console using six M3.5 X 8mm Black Zinc Screws (F1).

B1

C1

D1

Go Console

Connections

15P G 13P

		4P
		Track Console
15P	13P	Connections
		G
4P

E1

F1

3.10PLUG IN THE UNIT

Parts: Electric Transformer

Plug the black cord into the back of the machine and into a household electrical outlet.

13