Life Fitness LCD Entertainment Ready

INSTALLATION

9. Tilt the DISPLAYCONSOLE (--) forward and connect the I-R CON-

TROL(A) and S-VIDEO (--) CABLES to the back of the DIS-

PLAYCONSOLE.

10. Tape the ends of the all CABLES (POWER, COAXIAL, I-R

CONTROL, S-VIDEO) together.

11. Feed the taped end of the MEDIA CABLES (--) through the

large hole in the back of the CONSOLE BRACKET (--).

Carefully pull excess MEDIACABLE through the CONSOLE

BRACKET .

12. Slide one GROMMET (--) over the taped end of the MEDIA

CABLES (--).

13. Holding the MAIN BRACKET ASSEMBLY(--) close to the CON-

SOLE BRIDGE (--) as shown. With the holes facing upward,

feed the taped end of the MEDIACABLES (--) through the BOT-

TOM LARGE HOLE of the MAIN BRACKETASSEMBLY and out

of the UPPER HOLE as shown. Carefully pull excess MEDIA

CABLE through the MAIN BRACKETASSEMBLY.

14. Slide the remaining GROMMET (--) over the taped end of the MEDIA

CABLES (--). Install the GROMMETS into the ACCESS HOLES.

15. Secure the MAIN BRACKET ASSEMBLYusing four SCREWS (--) and WASHERS (--) as

shown. Tighten the SCREWSsecurely. (8-10 ft. lbs.)

16. Install the MAIN BRACKET CAPS (--) to the top and bottom of the MAIN BRACKET

ASSEMBLY(--).

17. With the remaining TV BRACKET (--) oriented as shown, install it to the back of the

TV (--)using four SCREWS (--) and WASHERS (--). Tighten the SCREWS

securely. (8-10 ft. lbs.)

NOTE: Be sure the side holes of the TV BRACKET are oriented as

shown.

18. Position the TV BRACKETS (-- & --) together as shown below and

secure them together using one BOLT(--), WASHER (--) and NUT (--

). Leave the BOLTand NUT loose at this time.

NOTE: Be sure the PIVOT POSTof the TV BRACKET (--) engages

onto TV BRACKET (--).

19. Remove the tape from the end of the MEDIA CABLES (POWER, COAXIAL, I-R

CONTROL, S-VIDEO). Connect all cables to their corresponding jacks located on

the back of the TV (--) (See end of instruction manual for TV connection details).

Feed any excess MEDIACABLE into the MAIN BRACKET (--).

20. Tilt the DOSPLAY CONSOLE back into place. Replace the

REAR CONSOLE COVER (--) and secure it using the previ-

ously removed six SCREWS (--). Tighten the SCREWS

securely. (8-10 ft. lbs.). Do not over-tighten the SCREWS.

21. Align the LOWEST SIDE HOLES on the TV BRACKETS

(-- & --). Secure the TV BRACKETinto proper position

using one SCREW (--) on each side.

NOTE: Life Fitness recommends aligning and securing

the TV at the lowest side holes ???? (--) as shown.

22. Plug in and power on the TV. Refer to the Owners Manual for

proper TV setup.