SM40 Unpacking & Assembly Instructions
17
The parts shown in Hardware Figure 1 are used to assemble the SM40. They are:
A. 7/16” x 6” hex head bolt (used to bolt the tricep top beam, adjustable crossover top
beam, lat top beams, and connecting beam to the tops of the cubes)
B. 7/16” flat washer
C. 7/16” cap washer (used on the head end of the 6” bolt so end cap will fit on the nut)
D. 7/16” hex head nut
E. 3/8” x 3” hex head bolt (used to bolt the cross beam to the cross members, the
adjustable pulley tops to the top beams, and the bottom bolts on the lat benches)
F. 3/8” x 2-3/4” hex head bolt (used for all other connections)
G. End caps (bolt covers)
H. 3/8” flat washer
J. 3/8” end cap washers (end caps snap onto them)
K. 3/8” Nyloc (locknut)
The black rubber caps shown in Hardware Figure 2 are used to cap the ends of the cables
that are threaded to the adjustable pulleys.
Hardware Figure 2. Rubber caps.
L. Rubber cap