SM50 Unpacking & Assembly Instructions
15
Bolt the cable to the weight stacks as shown in Figure 18. Thread the 7/8” nut up on the
cable bolt as shown at left. Screw the bolt down into the weight stack as shown at right.
Tighten the bolt with a 7/8” combination wrench.
Figure 18. Screw the cable into the weight stack.
LAT PULLDOWN CABLE ROUTING
Route the lat pulldown cable as shown in Figure 19. Screw the cable into the weight stack as
shown previously in Figure 18.
Figure 19. Lat pulldown cable routing.