Life Fitness ST35 user manual Service And Technical Data, Preventative Maintenance Tips

5 SERVICE AND TECHNICAL DATA

5.1PREVENTATIVE MAINTENANCE TIPS

Use a vacuum cleaner or a slightly damp cloth to remove dust from the treadmill periodically.

WARNING: Do not use any solvents on the deck or running belt, as these can reduce lubrication.

Also, fold up the treadmill and vacuum the floor beneath and around it periodically to prolong the life of the unit.

5.2TROUBLESHOOTING THE TELEMETRY HEART RATE CHEST STRAP

HEART RATE READING IS ERRATIC OR ABSENT ENTIRELY

•Repeat the electrode moistening procedure on the chest strap. See Section 3.2, titled Heart Rate Monitoring for details. The electrodes must remain wet to pick up and transmit accurate heart rate readings.

•Make sure the electrodes are flat against the skin.

•Wash the belt transmitter regularly with mild soap and water.

•Make sure the chest strap transmitter is within three feet (91 centimeters) of the console.

•The chest strap is battery-operated and will stop functioning when the battery runs out. Contact Customer Support Services for instructions on how to have the chest strap replaced. See Section 5.3, titled How to Obtain Product Service.

HEART RATE READING IS ERRATIC OR EXTREMELY HIGH

If the chest strap is worn near sources of electromagnetic signals, these signals may be strong enough to elevate heart rate readings. Possible sources include:

•Television sets and/or antennas, cell phones, computers, cars, high voltage power lines and other motor driven exercise equipment.

•Another heart rate transmitter within three feet, or one meter, may also cause abnormal heart rate readings.

5.3WHEN AND HOW TO OBTAIN PRODUCT SERVICE

IDENTIFYING PROBLEMS

In the event of an electrical failure, the treadmill shuts down immediately.

Generally speaking, if the console’s displays or programs do not function properly, try switching it off and on. Doing so often clears problems by resetting the treadmill computer’s memory. If restarting the treadmill does not eliminate the problem, call Customer Support.

•No signal on the monitor LCD windows: It is often possible to correct this problem by restarting the treadmill. If not, check the communication cable between the monitor and motor controller, and make sure that the cable isn’t pinched or damaged.

•Displayed “ERROR 1-SPEED SENSOR ERROR”: This indicates that the computer is not picking up the motor speed signal. Note whether the belt moves at all when the START key is pressed. If so, note whether the motor stops at low speeds, such as .6 mph to 1 mph (1.0kmh to 1.5 kmh) or high speeds, such as 6 mph to 8 mph (10kmh to 12 kmh). These details are important in helping Customer Service diagnose and solve the problem.

•Displayed “ERROR 2-OVER SPEED ERROR”: This problem actually is a safety function referred to as “run away protection”. When the belt speed exceeds the computer’s speed detection range, the treadmill motor shuts down, and the MESSAGE CENTER displays the Error 2 message. In this case, simply restart the treadmill. If the MESSAGE CENTER displays this message before the unit is ever used, or if the MESSAGE CENTER displays this message at speeds within the detection range, the mechanism is damaged.

•Displayed “ERROR 3-SAFETY KEY TETHER ERROR”: This indicates that the Emergency Stop Key is not cor- rectly inserted into the keyholder. Make sure that the key is properly inserted.

•Displayed “ERROR 5-INCLINE ERROR”: This indicates that the incline motor, which creates workout eleva-

21