Seated Row SU50 Customer Assembly Instructions
6
2. Bolt the cable to the weight stack. Thread the 7/8” nut up on the cable bolt as shown in
Figure 7. Screw the bolt down into the weight stack as shown in Figure 8. Tighten the bolt
with a crescent wrench or 7/8” open-end wrench.
Figure 7. Thread the nut onto the cable.
Figure 8. Screw the cable into the weight stack.
3. Align the cable in the pulley housings. From the weight stack, run the cable through
the upper section of the upper pulley (#1 in Figure 9). Align the cable into the pulley
groove and reinstall the pulley bolt. Run the cable through the lower section of the lower
pulley (#2 in Figure 9). Align the cable into the pulley groove and reinstall the pulley bolt.
Make sure you install the cable ABOVE the small bolt at the bottom of the housing.