2.4INSTALLING THE CONSOLE
Remove the pre-installed bolt (A) from the back of the main console (B). Position the main console near the top of the console bridge and attach the connectors leading from the console bridge to the corresponding tabs on the back of the main console. The wires are color wrapped to match colored tabs on the main con- sole circuit board. The main console harness (C) wrapped in a green sleeve corresponds with the green tab on the console circuit board. The Activity Zone harness (D) wrapped in a yellow sleeve corre- sponds with the yellow tab on the console circuit board. The grounding wire (E) is the small green and yellow wire that inserts onto any of the three metal cir- cuit board receptacles.
Be sure the connectors are fully seated together.
Feed any excess wire into the console bridge.
Attach the main console to the console bridge using three M8 x 25mm Zinc Bolts (6) and three Star Washers (3). Tighten the bolts securely.
CAUTION: Do not pinch the wires when attaching the main console to the console bridge.
Securely tighten all the bolts that were left finger-tight. Re-attach the motor cover using four Phillips screws.
