Installing an expansion card in riser cards | Expansion cards and iBBU |
|
|
|
|
Figure 27: Riser card holder equipped with a controller
ÊInsert the board into the riser card holder of the same height.
IMake sure that the rear cover is positioned in the designated groove.
ÊIf necessary, connect the cables to the expansion card and the other compo- nents.
Reinstalling the riser card holders
ÊPosition the riser card holder over the relevant slot on the system board.
ÊCarefully push the riser card holder into the slot by pressing on the green points.
ÊClose the server, connect all power plugs to the power outlets, and switch on the server as described in chapter “Completion” on page 61.
50 | Options Guide | RX200 S5 |
