Opening the server | Fujitsu RX200 S5 instruction

Preparation	Opening the server

Figure 4: Using the locking levers

ÊPush the green locking levers together as shown (1) and then move them up (2) so that the housing cover is pushed backward slightly.

ÊLift off the housing cover upwards.

RX200 S5

Options Guide

21

Image 21

Fujitsu RX200 S5 manual Opening the server

Contents

Primergy RX200 S5 Server Certified documentation according to DIN EN ISO Comments… Suggestions… Corrections… Contents Contents Preface Concept and target groupsDocumentation overview Further sources of information Documentation overview Preface Expansions and conversions TPM Expansions and conversions Preface Notational conventions Page Procedure Page Safety instructions Before starting up Installation and operation Options Guide Batteries Working with CDs/DVDs and CD/DVD drives Laser informationNever remove parts of the CD/DVD drive casing ESD label Modules with electrostatic-sensitive components Pulling out/removing the server Preparation Opening the server Removing the housing coverOpening the server Preparation Removing the fan cover Opening the server Removing the air cowl Preparation Removing the air cowl Processors Installing a second processor Inserting the processor Installing a second processor Processors Installing the heat sink Replacing the processor Replacing the processor Replacing the processor Replacing the processor Replacing the heat sink Page Main memory Mirrored Channel Mode Independent Channel ModeEquipping rules Equipping rules Performance Channel Mode Spare Channel ModeMain memory Removing installed memory modules Extending/replacing the main memoryExtending/replacing the main memory Inserting a memory module Inserting memory modulesPage Accessible drive Installing a Sata DVD drive Installing a Sata DVD drive Installing a Sata DVD drive Page HDD modules Removing the DVD drive or dummy module Removing an existing DVD drive or dummy module Demounting the DVD drive cage Removing the DVD drive cage Removing the existing backplane 6x HDD Installing the backplane 8x HDD Installing the HDD drive cage Installing the drive cage for 8x HDD Inserting the HDD modules HDD #6 HDD #7 Expansion cards and iBBU Installing an expansion card in riser cards Installing an expansion card in riser cards Installing an expansion cardRemoving the riser card holders Riser card holder #2 with riser card Riser card holder equipped with a controller Reinstalling the riser card holders Installing a RAID controller Installing a modular RAID controllerInstalling the riser card holder Expansion cards and iBBU Installing an iBBU Installing an iBBU Installing an iBBU Installing the iBBU IBBU Routing the cable Connecting the cable to the modular RAID 5 controller Position of the uSSD on the system board USB solid state disk uSSDPage Trusted Platform Module TPM Installing the TPM modulePage Fitting the air cowl Completion Fitting the air cowl Dimm CPU #1 Completion Fan #3/#4 Fan #1/#2 Fan #11/#12 Fit the fan cover see Removing the fan cover on Closing the serverPage Cabling Cabling overviewDescription From Cable diagrams Cabling Cable diagrams Cabling for up to 6 HDD modules Cabling for up to 8 HDD modules Index